Professional mulcher from European production, can be used for crushing crop residues, fruit residues in orchards or in vineyards. Ideal for maintaining grassland or meadows and park areas. Three-point hitch Cat II and Cat III (sockets), heavy cast iron gearbox, leveling roller with stable scraper rail, encapsulated bearings on the flail shaft.

Electronically finely balanced flail shaft for smooth, low-vibration operation. Holders for the hammer flails "thickness of the thumb" and neatly welded to the flail shaft.

Hydraulically adjustable double headstock to operate the mulcher off-centre. Attachment as a rear or front mulcher with 540 rpm possible (version in 1000 rpm as a conversion kit on request) Robust housing (not to be compared in material strength with all "China / Far East - imports) in very good material strength. Heavy slats as stone chip protection, side skids (also much thicker material than any "China mulcher").

3-way adjustable counter blade to shred the mulch optimally. Thanks to the cast hammer flails, branches up to 60mm thick are no problem.

Your tractor should have at least 50 hp to be able to drive this mulcher safely.

You will find the right cardan shaft here.

The mulcher comes fully assembled and lubricated, so it is ready for immediate use. After a short run-in phase, please tighten the belts again to prevent slipping and premature wear.

Professional mulcher from European production, can be used for crushing crop residues, fruit residues in orchards or in vineyards. Ideal for maintaining grassland or meadows and park areas. Three-point hitch Cat II and Cat III (sockets), heavy cast iron gearbox, leveling roller with stable scraper rail, encapsulated bearings on the flail shaft.

Electronically finely balanced flail shaft for smooth, low-vibration operation. Holders for the hammer flails "thickness of the thumb" and neatly welded to the flail shaft.

Hydraulically adjustable double headstock to operate the mulcher off-centre. Attachment as a rear or front mulcher with 540 rpm possible (version in 1000 rpm as a conversion kit on request) Robust housing (not to be compared in material strength with all "China / Far East - imports) in very good material strength. Heavy slats as stone chip protection, side skids (also much thicker material than any "China mulcher").

3-way adjustable counter blade to shred the mulch optimally. Thanks to the cast hammer flails, branches up to 60mm thick are no problem.

Your tractor should have at least 50 hp to be able to drive this mulcher safely.

You will find the right cardan shaft here.

The mulcher comes fully assembled and lubricated, so it is ready for immediate use. After a short run-in phase, please tighten the belts again to prevent slipping and premature wear.